Use this electronics calculation for a first-pass component, converter, signal, motor, or sensor estimate when the stated operating conditions and units match the device data.

Excitation (V) (V)

Required number input.

Gauge Factor

Required number input.

Strain

Required number input.

Calculate the exact ideal quarter-bridge voltage change for one active strain-gauge arm from excitation voltage, gauge factor, and mechanical strain; bridge polarity follows the changed arm. The tool evaluates the supplied inputs together and returns the named outputs below; it does not infer omitted operating conditions or change the units shown.^[1]

Bridge Output (V) (V)

The resulting bridge output (v) returned as a number.

• Strain-gauge output depends on gauge factor, bridge configuration, excitation, lead resistance, transverse sensitivity, temperature compensation, bonding, alignment, creep, and amplifier offset. Mechanical strain transfer and calibration determine measurement accuracy.
• Use finite inputs in the displayed units and preserve more precision than the final presentation requires. Independently verify safety-critical, financial, compliance, or production decisions.

Check the result against the current datasheet and worst-case operating corners, then verify the circuit or measurement with simulation and bench testing where failure matters.

• Ideal DAC Output Voltage

  Calculate an ideal unipolar DAC code's voltage as Vref×code/2^N. The top code is one LSB below Vref; this does not include offset, gain, or integral nonlinearity.

• ADC LSB Voltage

  Calculate one ideal ADC code width as full-scale input span divided by 2^N. Full-scale span is the high-to-low range, not necessarily the reference voltage for every ADC topology.

• LVDT Output Voltage

  Calculate linear-region LVDT output voltage from calibrated sensitivity in volts per millimeter and signed core displacement; excitation and demodulation are assumed fixed.