Use this electronics calculation for a first-pass component, converter, signal, motor, or sensor estimate when the stated operating conditions and units match the device data.

Transfers per second

Required number input.

Bytes per transfer

Required number input.

Parallel channels

Required integer input.

Calculate theoretical aggregate bandwidth from transfers per second, bytes per transfer, and active channels. Output is decimal GB/s (10⁹ bytes/s); protocol overhead and idle cycles are excluded. The tool evaluates the supplied inputs together and returns the named outputs below; it does not infer omitted operating conditions or change the units shown.^[1]

Bandwidth Bytes Per Second

The resulting bandwidth bytes per second returned as a number.

Bandwidth Gb Per Second

The resulting bandwidth gb per second returned as a number.

• Signal-integrity estimates depend on edge rate, channel loss, impedance discontinuities, termination, encoding, equalization, clock recovery, jitter decomposition, crosstalk, connectors, vias, and receiver masks. Aggregate budgets must use compatible statistical or worst-case conventions.
• Use finite inputs in the displayed units and preserve more precision than the final presentation requires. Independently verify safety-critical, financial, compliance, or production decisions.

Check the result against the current datasheet and worst-case operating corners, then verify the circuit or measurement with simulation and bench testing where failure matters.

• Gyroscope Voltage Output

  Calculate linear analog gyroscope voltage from zero-rate voltage, sensitivity in volts per degree per second, and signed angular rate.

• LVDT Output Voltage

  Calculate linear-region LVDT output voltage from calibrated sensitivity in volts per millimeter and signed core displacement; excitation and demodulation are assumed fixed.

• MIPI Lane Rate

  Calculate required per-lane serial rate from aggregate payload rate, active lane count, and specified usable payload efficiency.