Use this electronics calculation for a first-pass component, converter, signal, motor, or sensor estimate when the stated operating conditions and units match the device data.

Bus voltage (V)

Required number input.

Switch current (A)

Required number input.

Voltage transition time (s)

Required number input.

Current transition time (s)

Required number input.

Estimate one hard-switching event's voltage-current overlap energy with linear current and voltage transitions; excludes tail current and parasitics. The tool evaluates the supplied inputs together and returns the named outputs below; it does not infer omitted operating conditions or change the units shown.^[1]

Approximate switching energy (J)

The resulting approximate switching energy returned as a number.

• IGBT conduction and switching calculations depend on gate drive, collector current, junction temperature, bus voltage, stray inductance, switching speed, diode recovery, and datasheet test conditions. Safe operating area and transient thermal impedance must be checked separately.
• Use finite inputs in the displayed units and preserve more precision than the final presentation requires. Independently verify safety-critical, financial, compliance, or production decisions.

Check the result against the current datasheet and worst-case operating corners, then verify the circuit or measurement with simulation and bench testing where failure matters.

• BJT Early Voltage Effect

  Estimate collector current at a new collector-emitter voltage using the linear Early-effect model at fixed base drive.

• Current Sensor Output Voltage

  Calculate linear current-sensor output voltage from zero-current offset, volts-per-ampere sensitivity, and signed current.

• MOSFET Switching Loss

  Compute MOSFET switching loss as 0.5 x V x I x (tr + tf) x f for hard-switched transitions.