Use this electronics calculation for a first-pass component, converter, signal, motor, or sensor estimate when the stated operating conditions and units match the device data.

Aggressor (V) (V)

Required number input.

Near End Coupling Fraction

Required number input.

Estimate near-end crosstalk voltage from a measured or specified dimensionless near-end coupling coefficient and aggressor voltage; this is not a cable-geometry prediction. The tool evaluates the supplied inputs together and returns the named outputs below; it does not infer omitted operating conditions or change the units shown.^[1]

Near End (V) (V)

The resulting near end (v) returned as a number.

• Crosstalk estimates depend on geometry, coupled length, rise time, termination, reference planes, direction, and modal propagation. A lumped coupling coefficient cannot replace a transmission-line model for electrically long interconnects.
• Use finite inputs in the displayed units and preserve more precision than the final presentation requires. Independently verify safety-critical, financial, compliance, or production decisions.

Check the result against the current datasheet and worst-case operating corners, then verify the circuit or measurement with simulation and bench testing where failure matters.

• Crosstalk Far End Voltage

  Estimate far-end crosstalk voltage from a measured or specified dimensionless far-end coupling coefficient and aggressor voltage; this is not a cable-geometry prediction.

• GaN HEMT Rds On Tempco

  Calculate average GaN HEMT on-resistance temperature coefficient as percent change per Celsius degree between two measured temperatures; this is not a local derivative.

• Humidity Sensor Accuracy

  Apply a sensor's specified absolute percent-RH accuracy to a measured relative humidity reading; this is not a confidence interval.