Use this workshop calculation to turn measured dimensions and the selected construction convention into a cut, spacing, fit, or material-planning value.

Panel Thickness Mm (mm)

Required number input.

Edge-banding width needed for a panel thickness with 1 mm trimming overhang on both faces. The tool evaluates the supplied inputs together and returns the named outputs below; it does not infer omitted operating conditions or change the units shown.^[1]

Banding Width Mm (mm)

The resulting banding width mm returned as a number.

• Nominal dimensions, kerf, moisture movement, hardware clearances, wall squareness, and manufacturer instructions can change the required shop dimension. Measure the actual assembly and test critical joints on scrap before cutting finished material.
• Use finite inputs in the displayed units and preserve more precision than the final presentation requires. Independently verify safety-critical, financial, compliance, or production decisions.

Complement the calculated dimension with a physical story stick, dry fit, or full-size layout. Follow the hardware, coating, adhesive, or machine manufacturer's limits where they differ from a rule of thumb.

• Edge Banding Trim Allowance Calculator

  Compute the finished edge banding length after trimming both ends from the rough length and per-end trim allowance.

• Edge Banding Trim Allowance

  Calculate total edge-banding width to trim and the equal amount per face when strip is centered on a panel.

• Edge Banding Length

  Sum exposed panel edges and add an explicit allowance for trimming and waste.