Use this workshop calculation to turn measured dimensions and the selected construction convention into a cut, spacing, fit, or material-planning value.

Rough length (mm)

Rough edge banding length before trimming in millimetres.

Trim allowance (mm)

Material trimmed from each end in millimetres.

Compute the finished edge banding length after trimming both ends from the rough length and per-end trim allowance. The tool evaluates the supplied inputs together and returns the named outputs below; it does not infer omitted operating conditions or change the units shown.^[1]

Final length after trim (mm)

Remaining length after trimming both ends, which must stay positive.

• Nominal dimensions, kerf, moisture movement, hardware clearances, wall squareness, and manufacturer instructions can change the required shop dimension. Measure the actual assembly and test critical joints on scrap before cutting finished material.
• Use finite inputs in the displayed units and preserve more precision than the final presentation requires. Independently verify safety-critical, financial, compliance, or production decisions.

Complement the calculated dimension with a physical story stick, dry fit, or full-size layout. Follow the hardware, coating, adhesive, or machine manufacturer's limits where they differ from a rule of thumb.

• Kanten Anleimer Ueberstand 1mm Fraesen

  Edge-banding width needed for a panel thickness with 1 mm trimming overhang on both faces.

• Edge Banding Length

  Sum exposed panel edges and add an explicit allowance for trimming and waste.

• Edge Banding Trim Allowance

  Calculate total edge-banding width to trim and the equal amount per face when strip is centered on a panel.