Beat Error to Degrees Calculator
Declaredfullcyclephaseangleofactualtimeerror360ft,not half-beatdifferenceora safe escapementadjustment. Actual independently established geometry,calibration,product/rubricedition,units and applicability;not provenance,identity,grade,safe procedure or operational/compliance approval.
Description
A timing error can be expressed as a full-cycle phase angle using the oscillator frequency.
A timing error can be expressed as a full-cycle phase angle using the oscillator frequency.1
This convention must be distinguished from a manufacturer's beat-error adjustment procedure.
When to use Beat Error to Degrees Calculator
Use this tool to apply the stated beat error to degrees calculator operation with an explicit input and unit basis.
How to use Beat Error to Degrees Calculator and how it works
- Establish the measurement basis and units described above.
- Enter actualBeatErrorMilliseconds, actualOscillationFrequencyHz and run the tool.
- Read result.value using the output meanings below.
- If input is rejected, correct the stated type, range, ordering or alignment issue and rerun; review successful results under the declared convention.
| Input field | Meaning | Value type | Requirement |
|---|---|---|---|
| actualBeatErrorMilliseconds | Beat error milliseconds, on the basis specified in the algorithm. | number | required; finite; nonnegative; further conditions in the algorithm |
| actualOscillationFrequencyHz | Oscillation frequency hz, on the basis specified in the algorithm. | number | required; finite; strictly positive; further conditions in the algorithm |
Require nonnegative milliseconds and positive oscillation hertz. Multiply milliseconds by frequency and 360, then divide by 1000.
phase degrees = milliseconds × Hz × 360/1000 Apply the declared units, ordering and branch conditions.
| Output field | Meaning | Value type |
|---|---|---|
| result | Object containing the declared output fields. | object |
| result.value | Full-cycle phase angle in degrees; not reduced modulo 360. | number |
{
"input": {
"actualBeatErrorMilliseconds": 1,
"actualOscillationFrequencyHz": 2
},
"output": {
"result": {
"value": 0.72
}
}
}Limitations and assumptions
The output applies the declared operation to the values you supply. Establish the measurement basis, units, coefficients and any caller-selected rules before interpreting it. The tool does not independently collect or verify observations or decide whether a model or reference applies.
Supply explicit required fields with the documented types and dense aligned arrays. Unknown fields, wrong types and nonfinite numbers are rejected. Branch-specific constraints are explained above. A successful false boolean, negative signed difference, empty slice or unresolved tie is distinct from an input error. Very large inputs or outputs may be rejected by shared resource limits.
Alternative or Complementary methods
For a related operation, use Tuning Fork Frequency to Beats Calculator. A tuning fork completes full oscillation cycles at its frequency in hertz.
For a related operation, use Lug Width to Strap Width Checker. Lug clearance compares the internal space between watch lugs with the strap width.
References
-
Beat Error to Degrees Calculator — tool.io
Similar or alternative tools
- Tuning Fork Frequency to Beats Calculator
A tuning fork completes full oscillation cycles at its frequency in hertz.
- Lug Width to Strap Width Checker
Lug clearance compares the internal space between watch lugs with the strap width.