Use this electronics calculation for a first-pass component, converter, signal, motor, or sensor estimate when the stated operating conditions and units match the device data.

Zero-bias capacitance (F)

Junction capacitance at zero reverse bias.

Reverse voltage (V)

Reverse bias applied across the junction.

Built-in potential (V)

Built-in potential of the junction.

Grading coefficient

Grading coefficient of the junction profile.

Compute the junction capacitance of a varactor diode from its zero-bias capacitance, reverse voltage, built-in potential, and grading coefficient. The tool evaluates the supplied inputs together and returns the named outputs below; it does not infer omitted operating conditions or change the units shown.^[1]

Junction capacitance (F)

Biased junction capacitance.

• Compact electronics formulas omit some combination of tolerances, temperature drift, bandwidth, loading, parasitics, noise spectrum, nonlinearity, clipping, calibration, layout, and device-specific limits. Typical datasheet values are not guaranteed limits.
• Use finite inputs in the displayed units and preserve more precision than the final presentation requires. Independently verify safety-critical, financial, compliance, or production decisions.

Check the result against the current datasheet and worst-case operating corners, then verify the circuit or measurement with simulation and bench testing where failure matters.

• MOSFET Threshold Voltage

  Estimate nMOS threshold with body effect from zero-body-bias threshold, body coefficient, surface potential, and nonnegative source-to-body bias.

• Chopper Amplifier Offset

  Input-referred residual DC offset of a chopper amplifier from its zero-input output offset and closed-loop voltage gain.

• Humidity Sensor Capacitance

  Calculate a linear humidity sensor's capacitance from its calibrated zero-RH capacitance and sensitivity per percentage point of relative humidity.