Use this electronics calculation for a first-pass component, converter, signal, motor, or sensor estimate when the stated operating conditions and units match the device data.

Inductance (H)

Required number input.

Capacitance (F)

Required number input.

Calculate the characteristic impedance of an LC network. The tool evaluates the supplied inputs together and returns the named outputs below; it does not infer omitted operating conditions or change the units shown.^[1]

Characteristic impedance (ohm)

The resulting characteristic impedance returned as a number.

• Compact electronics formulas omit some combination of tolerances, temperature drift, bandwidth, loading, parasitics, noise spectrum, nonlinearity, clipping, calibration, layout, and device-specific limits. Typical datasheet values are not guaranteed limits.
• Use finite inputs in the displayed units and preserve more precision than the final presentation requires. Independently verify safety-critical, financial, compliance, or production decisions.

Check the result against the current datasheet and worst-case operating corners, then verify the circuit or measurement with simulation and bench testing where failure matters.

• Ideal Capacitor Impedance

  Calculate ideal capacitive reactance Xc=−1/(2πfC) and its magnitude in ohms. ESR, ESL, leakage, and self-resonance are not included.

• Contactor Coil Current

  Calculate DC contactor-coil steady current from applied voltage and DC coil resistance; do not use this for AC inrush or inductive impedance.

• Headphone Impedance

  Calculate headphone impedance magnitude at a test frequency from RMS terminal voltage and RMS current; phase is not determined.