Use this electronics calculation for a first-pass component, converter, signal, motor, or sensor estimate when the stated operating conditions and units match the device data.

Input voltage (V)

Required number input.

Time interval (s)

Required number input.

Resistance (Ω)

Required number input.

Capacitance (F)

Required number input.

Compute the op-amp integrator ramp voltage after a time interval as -(Vin x t) / (R x C). The tool evaluates the supplied inputs together and returns the named outputs below; it does not infer omitted operating conditions or change the units shown.^[1]

Ramp voltage (V)

The resulting ramp voltage returned as a number.

• Compact electronics formulas omit some combination of tolerances, temperature drift, bandwidth, loading, parasitics, noise spectrum, nonlinearity, clipping, calibration, layout, and device-specific limits. Typical datasheet values are not guaranteed limits.
• Use finite inputs in the displayed units and preserve more precision than the final presentation requires. Independently verify safety-critical, financial, compliance, or production decisions.

Check the result against the current datasheet and worst-case operating corners, then verify the circuit or measurement with simulation and bench testing where failure matters.

• RC Charging Voltage

  Compute the charging voltage across an RC network after a given elapsed time.

• RC Discharging Voltage

  Compute the remaining voltage across a discharging RC network after a given elapsed time.

• Op-Amp Open-Loop Gain

  Calculate open-loop voltage gain A=Vout/(V+−V−) from an unsaturated operating-point measurement. Differential input cannot be zero; this scalar does not capture frequency-dependent gain.