Use this workshop calculation to turn measured dimensions and the selected construction convention into a cut, spacing, fit, or material-planning value.

Rafix system

Rafix connector system: rafix-20 or rafix-22.

Look up the Rafix cam diameter, drilling depth, and edge distance for a given connector system. The tool evaluates the supplied inputs together and returns the named outputs below; it does not infer omitted operating conditions or change the units shown.^[1]

Cam diameter (mm)

Cam diameter in millimeters.

Drilling depth (mm)

Drilling depth for the cam housing in millimeters.

Edge distance (mm)

Center distance of the cam housing from the panel edge in millimeters.

• Nominal dimensions, kerf, moisture movement, hardware clearances, wall squareness, and manufacturer instructions can change the required shop dimension. Measure the actual assembly and test critical joints on scrap before cutting finished material.
• Use finite inputs in the displayed units and preserve more precision than the final presentation requires. Independently verify safety-critical, financial, compliance, or production decisions.

Complement the calculated dimension with a physical story stick, dry fit, or full-size layout. Follow the hardware, coating, adhesive, or machine manufacturer's limits where they differ from a rule of thumb.

• Clamex P Drilling Pattern

  Look up the P-System groove depth, 6 mm lever-access hole, and minimum butt-joint and miter material thicknesses for Clamex P-10 and P-14 connectors.

• Minifix 34mm Drilling Pattern

  Look up the fixed Minifix 34 mm drilling pattern for 16, 18, and 19 millimeter panels.

• Confirmat Drilling Pattern

  Compute the drilling pattern for a 7x50 confirmat connector in chipboard.