Use this workshop calculation to turn measured dimensions and the selected construction convention into a cut, spacing, fit, or material-planning value.

Resin mass (g)

Weighed resin amount in grams.

System

Epoxy mixing system ratio: 1:1, 2:1, or 5:1.

Compute hardener grams from resin grams and an epoxy mixing system ratio. The tool evaluates the supplied inputs together and returns the named outputs below; it does not infer omitted operating conditions or change the units shown.^[1]

Resin parts

Resin parts by volume or weight in the mixing ratio.

Hardener parts

Hardener parts by volume or weight in the mixing ratio.

Hardener mass (g)

Required hardener mass in grams.

• Nominal dimensions, kerf, moisture movement, hardware clearances, wall squareness, and manufacturer instructions can change the required shop dimension. Measure the actual assembly and test critical joints on scrap before cutting finished material.
• Use finite inputs in the displayed units and preserve more precision than the final presentation requires. Independently verify safety-critical, financial, compliance, or production decisions.

Complement the calculated dimension with a physical story stick, dry fit, or full-size layout. Follow the hardware, coating, adhesive, or machine manufacturer's limits where they differ from a rule of thumb.

• Glue Application Rate Lookup

  Look up the recommended glue amount in grams per square metre for one-sided or two-sided application.

• Stain Mixing Ratio

  Volumes of stain concentrate and thinner needed for a target mixed volume at a supplied concentrate-to-thinner parts ratio.

• Stain Dilution Ratio Calculator

  Calculate the thinner-to-stain dilution ratio and the resulting diluted volume.