Use this electronics calculation for a first-pass component, converter, signal, motor, or sensor estimate when the stated operating conditions and units match the device data.

Timing resistor (Ω)

Required number input.

Timing capacitor (F)

Required number input.

Compute the monostable pulse width of an NE555 timer from the timing resistor and capacitor. The tool evaluates the supplied inputs together and returns the named outputs below; it does not infer omitted operating conditions or change the units shown.^[1]

Pulse width (s)

The resulting pulse width returned as a number.

• Ideal 555 timing equations neglect threshold tolerance, discharge saturation, leakage, capacitor tolerance and dielectric absorption, output loading, supply variation, and the differences between bipolar and CMOS variants. Very short or long intervals need datasheet verification.
• Use finite inputs in the displayed units and preserve more precision than the final presentation requires. Independently verify safety-critical, financial, compliance, or production decisions.

Check the result against the current datasheet and worst-case operating corners, then verify the circuit or measurement with simulation and bench testing where failure matters.

• NE555 Astable Frequency

  Compute the astable oscillation frequency of an NE555 timer from R1, R2 and the timing capacitor.

• Holdup Time

  Compute the holdup time of a bulk capacitor from the energy delivered between the input and minimum voltages at a constant load power.

• RC Charging Voltage

  Compute the charging voltage across an RC network after a given elapsed time.