Use this electronics calculation for a first-pass component, converter, signal, motor, or sensor estimate when the stated operating conditions and units match the device data.

Reflection coefficient

Required number input.

Compute the mismatch loss in decibels caused by a reflection coefficient. The tool evaluates the supplied inputs together and returns the named outputs below; it does not infer omitted operating conditions or change the units shown.^[1]

Mismatch loss (dB)

The resulting mismatch loss returned as a number.

• RF gain, noise, compression, intercept, mismatch, sensitivity, and link calculations require consistent impedance, bandwidth, frequency, reference plane, temperature, modulation, and cascade ordering. Datasheet values at different conditions cannot be combined without correction.
• Use finite inputs in the displayed units and preserve more precision than the final presentation requires. Independently verify safety-critical, financial, compliance, or production decisions.

Check the result against the current datasheet and worst-case operating corners, then verify the circuit or measurement with simulation and bench testing where failure matters.

• Return Loss dB

  Compute the return loss in decibels from a reflection coefficient magnitude.

• Fiber Attenuation dB

  Compute the total attenuation of an optical fiber link from its loss coefficient and length.

• PCB Impedance Mismatch Reflection

  Calculate signed voltage reflection coefficient at a PCB transmission-line load as (Zload−Z0)/(Zload+Z0) for real positive impedances.