Use this electronics calculation for a first-pass component, converter, signal, motor, or sensor estimate when the stated operating conditions and units match the device data.

Magnetic flux (Wb)

Required number input.

Area (m²)

Required number input.

Compute flux density in teslas as magnetic flux in webers divided by area in square meters. The tool evaluates the supplied inputs together and returns the named outputs below; it does not infer omitted operating conditions or change the units shown.^[1]

Flux density (T)

The resulting flux density returned as a number.

• Magnetic-field and heading results depend on axis alignment, calibration, hard- and soft-iron distortion, local inclination, temperature, nearby current, sensor saturation, and tilt compensation. A field magnitude alone does not provide a reliable compass heading.
• Use finite inputs in the displayed units and preserve more precision than the final presentation requires. Independently verify safety-critical, financial, compliance, or production decisions.

Check the result against the current datasheet and worst-case operating corners, then verify the circuit or measurement with simulation and bench testing where failure matters.

• Magnetic Flux Wb

  Compute magnetic flux in webers as flux density in teslas multiplied by area in square meters.

• Core Flux Density

  Estimate the peak core flux density in tesla with the transformer equation B = V * 10^4 / (4.44 * f * A * N) using a core area in square centimeters.

• Inductor Steinmetz Core Loss Density

  Estimate magnetic-core loss density with a fitted Steinmetz power law p=k f^α B^β. Units of k must match the selected frequency, peak flux-density, and desired output units; the model applies only over its fitted waveform/range.