Use this electronics calculation for a first-pass component, converter, signal, motor, or sensor estimate when the stated operating conditions and units match the device data.

Dropout voltage (V)

Required number input.

Input voltage (V)

Required number input.

Output voltage (V)

Required number input.

Compute LDO dropout headroom as input minus the sum of output and dropout voltages; negative values indicate insufficient headroom. The tool evaluates the supplied inputs together and returns the named outputs below; it does not infer omitted operating conditions or change the units shown.^[1]

Dropout headroom (V)

The resulting dropout headroom returned as a number.

• Compact electronics formulas omit some combination of tolerances, temperature drift, bandwidth, loading, parasitics, noise spectrum, nonlinearity, clipping, calibration, layout, and device-specific limits. Typical datasheet values are not guaranteed limits.
• Use finite inputs in the displayed units and preserve more precision than the final presentation requires. Independently verify safety-critical, financial, compliance, or production decisions.

Check the result against the current datasheet and worst-case operating corners, then verify the circuit or measurement with simulation and bench testing where failure matters.

• Voltage Attenuator Ratio

  Compute the linear voltage attenuation ratio from output over input voltage.

• Programmable Gain Amplifier Gain

  Linear voltage gain at a selected programmable-amplifier setting from measured input and output amplitude.

• Linear Voltage Gain

  Compute the linear voltage gain as the ratio of output to input voltage.